We characterized the dependence of the timing jitter of an InGaAs/InP single-photon avalanche diode on the excess bias voltage（V（ex）） when operated in 1-GHz sinusoidally gated mode.The single-photon avalanche diode was cooled to-30 degrees Celsius.When the V（ex） is too low（0.2 V-0.8 V） or too high（3 V-4.2 V）,the timing jitter is increased with the V（ex）,particularly at high V（ex）.While at middle V（ex）（1 V-2.8 V）,the timing jitter is reduced.Measurements of the timing jitter of the same avalanche diode with pulsed gating show that this effect is likely related to the increase of both the amplitude of the V（ex） and the width of the gate-on time.For the 1-GHz sinusoidally gated detector,the best jitter of 93 ps is achieved with a photon detection efficiency of 21.4%and a dark count rate of -2.08×10 -5 per gate at the V（ex） of 2.8 V.To evaluate the whole performance of the detector,we calculated the noise equivalent power（NEP） and the afterpulse probability（P（ap））.It is found that both NEP and P（ap） increase quickly when the V（ex） is above 2.8 V.At -2.8-V V（ex）,the NEP and P（ap） are -2.06×10-（16）W/Hz-（1/2） and 7.11%,respectively.Therefore,the detector should be operated with V（ex） of 2.8 V to exploit the fast time response,low NEP and low P（ap）.
